VRS-S_product
VRS-S_dims

Vertical Reference Gyro VRS-S132-1AD (Single Axis)

The VRS-S132-1AD provides a digital RS-232 output along with analog data. A triaxial accelerometer is used rather than pendulums for a wider vertical reference sensing range.

Features:

  • Solid State, Strapdown System
  • High Accuracy
  • Low Cost, Low Power
  • Rugged, High Reliability
  • Analog and RS-232 Digital Outputs
  • One Year Limited Warranty
  • Engineering Support

Request a Quote

SKU: VRS-S132-1AD Category:

Product Description

The Watson Industries vertical reference System is a solid-state gyro package used to measure angular displacement and rate, especially where dynamic motion may interfere. Under these conditions, the effects of lateral accelerations severely limit the performance of an ordinary accelerometer or pendulous device. The Watson Vertical Reference achieves improved performance by integrating the output of a vibrating structure gyro to get an estimate of the attitude, which is then compared to the output of conventional accelerometers to find the error. This error is then filtered over a long time constant and subtracted from the rate gyro output to correct biases as a closed loop error correction system. This system lets the gyro dominate the attitude accuracy above the correction loop frequency while the accelerometer reference dominates the lower frequencies.

This sensor package uses smaller MEMS gyros. This allowed us to reduce the height of the VRS-S232 to almost half that of the VRS-E232.

The Watson vertical reference can be a functional replacement for mechanical vertical gyros, which are often more expensive and less reliable than this solid-state sensor. The Vertical Reference System is especially suited for applications where there is limited bank and elevation such as ships, underwater vehicles, some land vehicles, and certain camera applications. This is because the VRS uses a linear coordinate system. For better performance, a full three axis system would be required. Consult the factory about your application.

The VRS is used to stabilize and control ships and submersibles, to stabilize antenna and camera platforms, to instrument industrial equipment, and for many other applications.

Applications

Downloads

Download Spec Sheet (PDF - 65.2 KB)

 

Download Manual (PDF - 93.6 KB)

 

Specifications

Attitude

Range: Y Axis ±90° (±50°) Digital (Analog)
Resolution: 0.02° Binary mode (14 bit)
Analog Scale Factor: 5°/V ±10V Output
Accuracy: Static ±0.5° (up to 75°)
* Accuracy: Dynamic ±2%

Angular Rate

Range: Y Axis ±100°/sec
Resolution: 0.025°/sec Binary mode (14 bit)
Analog Scale Factor: 10°/sec/V ±10V Output
Scale Factor Accuracy: 2%
Bias: Y Axis < 0.3°/sec
Non-Linearity: < 0.05% Full scale range
Bandwidth: 20 Hz

Acceleration

Range: X, Z ±10g
Resolution: 4mg
Scale Factor Accuracy: 1%
Bias: X, Z < 10mg
Non-Linearity: 0.1% Full scale range
Bandwidth: 3 Hz

Environmental

Temperature: Operating -40°C to +85°C
Temperature: Storage -55°C to +85°C
Vibration: Operating 2.5g rms 20 Hz to 2 KHz
Vibration: Survival 10g rms 20 Hz to 2 KHz
Shock: Survival 500g 10mS ½ sine wave

Electrical

Frame Rate: 284.44 Hz Maximum
Startup Time: Data 5 sec
Startup Time: Fully operational 10 sec
Input Power: 10 to 30VDC 1.7W
Input Current: 125mA @ 12VDC 70mA @ 24VDC
Digital Output: RS-232
Analog Output: ±10VDC
Analog Output Impedance: 300 Ohm Per line

Physical

Axis Alignment: < 0.25°
Size: Including Mounting Flanges 3.24″W x 5.78″L x 2.38″H 8.2 x 14.7 x 6 (cm)
Weight: 19.4oz (1.2 lb) 550 grams (0.5 Kg)
Connection: RS-232 / Analog Outputs 9 pin female “D” subminiature
Connection: Power 9 pin male “D” subminiature
* Actual accuracy can be calculated as the listed percentage multiplied by the change in value over the entire dynamic maneuver.
Specifications are subject to change without notice.
This product may be subject to export restrictions. Please consult the factory.

Additional Information

Weight 0.549981 kg
Dimensions 8.2296 x 8.2296 x 6.0452 cm

Reviews

There are no reviews yet.

Be the first to review “Vertical Reference Gyro VRS-S132-1AD (Single Axis)”

Your email address will not be published. Required fields are marked *

This blog is kept spam free by WP-SpamFree.