Inertial Warehouse Navigation

For higher efficiency, reliability and lower costs, robotic material handling equipment are used to move shipments in large warehouses. An inertial navigation system is needed for the vehicle to negotiate its way through the building.

The gyros in this inertial navigation system must be extremely stable because the warehouse environment does not support the use of a magnetic or GPS heading reference.

For this application, Watson Industries produces the Dynamic Measurement System (DMS). The DMS provides the full array of sensors necessary in an inertial navigation system along with a relative heading output. Our gyros are also available for integration into larger navigation systems.

 

Watson Experience

Watson Industries been involved in the development and production of inertial navigation products for this application since 1988.

Technical Challenges

Navigation inside of a warehouse is a very challenging environment. Dead reckoning with occasional absolute fixes is used. The heading of the vehicle in needed so that its position in the warehouse can be calculated. Directly integrating a heading gyro will provide information on relative heading. Gyro drift and the Earth’s rotation will slowly cause errors in the heading reading. To overcome this difficulty, navigation systems typically employ a heading update system.

The two most common and cost-effective types of heading reference systems are a magnetic compass and GPS. Inside of a warehouse, the sensor cannot properly detect the Earth’s magnetic field and it shielded from the signal from GPS satellites. These challenges create the need for a relative heading system based on the direct integration of a rate gyro. To minimize heading errors during navigation, the gyro signal must be extremely stable. To remove residual errors, the warehouse should use a network of detectable fixed waypoints to periodically correct the relative heading.

Watson Industries has gyros that are ideally suited for this job. Our gyros have the low drift and stability specifications that are needed to provide an accurate relative heading signal.

 

Requirements

  • Low drift / noise
  • High reliability
  • Low life cycle cost

Typical Options

We are able to accommodate your custom needs. Go to our custom product modifications page for a listing of the most common custom options we support.